Retsch AS 200 control - natural frequency Manuel d'utilisateur télécharger pdf (Page 12)

Retsch GmbH 12

Operation

Operating elements and operation

A Cold apparatus plug combination

C Fuse compartment with 2 glass fuses

B Serial connection

D Protective cap for serial connection

E Switch ON / OFF, bottom left

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

PROG – button for calling preset sieving parameters P1-P9 or on and for ending

programming without storing the parameters.

Display memory shows the selected programme P1-P9 or on. If the AS 200 is driven by

the EasySieve

softwear programme ES appears in the display.

SET – button for activating the setting mode for the preselected programme positions P1-

P9 and for storing the parameters after programming.

▬ button reduces the amplitude 0.20 – 3.00mm, precision ±0.1mm, or sieve bottom

acceleration in „g“

Display amplitude shows the amplitude (2 x amplitude) of 0.20 – 3.00mm or sieve

bottom acceleration in „g“.

+ button increases the amplitude, 0.20 – 3.00mm, precision ±0.1mm, or sieve bottom

acceleration in „g“.

▬ button reduces the interval time, 10 – 99sec.

Display interval shows the preselected interval time, 10 – 99sec.

+ button increases the interval time, 10 – 99sec.

Button switches interval operation ON, left LED lights up.

Button switchces interval operation OFF, right LED lights up.

▬ button reduces the sieving time, 1 – 99min.

Display time shows the preselected sieving time, 1 – 99min.

+ button increases the sieving time, 1 – 99min.

START button starts the sieving process and the green LED lights up.

STOP button stops and ends the sieving process and the red LED lights up.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Pas de commentaire

Retsch AS 200 control - natural frequency Manuel d'utilisateur Page 12