Transport, scope of delivery, installation
15
Fig. 1: Removing the transport aids and mounting the sieve plate
• Loosen the two transport aids (TH). (1.)
Insert the sieve plate (ST) and make sure the alignment is correct. (2.)
• Screw the sieve plate on with the three provided screws (RA) to finger
tightness. The necessary torqueis approx. 40 Nm.
Then put the three protective caps (SK) onto the screws and press the
protective caps on securely.
Keep the two transport aids for transport at a later date.
4.7 Using the transport aids again
• Remove the three protective caps (SK)
• Loosen the three screws (RA) in the centre of the sieve plate.
• Lift the sieve plate (ST) off the device.
• Screw the two transport aids (TH) into the corresponding threaded bores.
Pos: 6.19 /00005 Ü berschriften/ 1.1 Überschrifte n/1.1 Überschrift en BDA/11 Be dieneinheit ansc hließen @ 0 \mod_1229076 747940_9.doc @ 5026 @ @ 1
4.8 Connect the control unit
Pos: 6.20 /00010 Bedienungsa nleitungen Ka pitelsammlungen/ AS450_control/ 0006 Transp ort, Lieferumfang und Aufstellen /A S450 Modul Bedieneinheit ansc hließen @ 0 \mod_1229 077266034_9.d oc @ 5032 @ @ 1
Fig. 2: Connecting the operating unit
• Insert connector C into the 9-pin port B13 on the operating unit.
Commentaires sur ces manuels