Retsch AS 200 tap 30.025.1001 Manuel d'utilisateur télécharger pdf (Page 15)

8 January 2008 Retsch GmbH 15 Doc. no. D 98.025.9999

Inserting the sieve stack

The AS 200 tap is suitable for analytical sieves with

outside diameters of 200 mm and 203 mm (8“).

To make it possible to loosen the clamping

screws easily, the position of the KH clamping

lever can be adjusted independently of the

clamping screws.

Then unscrew the two clamping screws C and

push the carriage downwards. Tighten both

clamping screws firmly again.

Place the sieve stack in the centre of the carriage

and loosen the two clamping screws.

Push the carriage upwards until the top edge of

the sieve stack is at the same level as the guide

ring. Then tighten the clamping screws again.

Lift the tapping arm slightly and place the sieve

lid E with cork stopper on the top sieve.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Pas de commentaire

Retsch AS 200 tap 30.025.1001 Manuel d'utilisateur Page 15